slide changes every 10 seconds

GARF'S AIRLIFT MAKING LESSON = bubbles and sun
LEROY@GARF.ORG



We will 1 1/2" pvc pipe for these airlifts. Using a cutoff saw we cut the pipe at a 45 degree angle. These two parts will make the bend in the airlift. You also use a 90 degree elbow fitting. The elbows cost about $2.00 each. If you need very many airlifts this method of making your own 90 degree cuts will save money that is better used on other materials.

The short piece of pipe has a hole the size of the the small tube drilled as close to the cut end as possible. The small tube is cut with slots around the end of the pipe.

2parts